Snap button type and installation steps
In many places in daily life, you can see snap button, such as clothes, bags and the like. So what are the types of snap button? How to install a snap button? Here is a detailed introduction to the types of Snap buttons and installation steps for everyone, I hope it’s helpful to everyone. The details about the type of snap button and the installation steps are as follows.
Snap button type
1. is the most primitive and simple type, the snap is sewn on the clothes with needlework.
2. is the kind of Snap button on the jacket or denim shirt, which is pressed by special manual machinery or electric machinery.
Snap button installation steps
1. First observe the dark Snap button components. The four-Snap button first divides the four sets of Snap buttons into a variety according to the following figure. The upper skin is a group, and the lower skin is another group installed.
2. First install the buckle surface, punch the hole with 3.5MM punch on the leather surface
3. Place the buckle on the base
4, the leather is placed on the buckle surface
5, install another matching part
6. Use the installation tool inside the installation tool set to install it. Note that the flat position should not be pressed to the thin spring wire in the Snap button, otherwise the whole must be scrapped.
7. Align the mold with the Snap button and install it. Beat it with a hammer. Pay attention to the strength. It is best to get it in one place.
8. Punch the other skin and prepare to install the Snap button on the other side.
9. Place the Snap button on the base
10.put the leather on the Snap button
11. Put the last raised Snap button on top
12.using a concave mold installation
13.he mold is aligned with the nail, and the hammer is vigorously beaten above, preferably once in place.
14.installed positive effects
The above is about the type of Snap button and the installation steps. I hope everyone can understand the installation type and installation steps, and it will help everyone.
